Pheasant season is right around the corner and if your dogs are anything like ours, they get into a lot of thick tall grass searching for the elusive scent of a pheasant. Often other creatures pop out of the underbrush, such as rabbits, deer and on occasion, a skunk. That happened on one hunting trip. The dogs were hot on a pheasant that wanted to run through some prairie grass and would not break cover, when the dogs stopped short. As I caught up to Charlie and Orso I could make out something black sticking up in the grass and the dogs were barking at it. I just barely made out the shape and screamed, “Skunk! Leave it –leave it!”
I back pedaled as fast as I could to get out of range, but Charlie and Orso were not so lucky. As Charlie turned the skunk sprayed them catching Charlie on the right side of his face and shoulder, Orso got sprayed on his shoulder. As bad as the dead skunk stench smells when you are driving down the road and get a waft of the road kill aroma, a live skunk spray victim smells worse. It is a cloying sickening sweet, decaying smell that gets in your nostrils and won’t go away.
We took the dogs back to the hotel and first put Charlie in the tub and used all of the shampoo we had scrubbing, rinsing and repeating over and over until the stench was not as overwhelming as it first was. A trip to Walmart for more shampoo and it was Orso’s turn. Even though we were able to cut the stench down with the multiple baths, the stench was still there when you got close to their heads and shoulders. It took almost six months for the smell to completely go away.
After we got back from our fateful hunting trip, we decided to put together a skunk de-skunking kit. In the October 2008 issue of Gun Dog Magazine there was an article about skunks and dogs and it listed a de-skunking recipe. Below is the list of ingredients and instructions for anyone that takes their dogs hiking or hunting and just might need this.
16 ounce bottle of Hydrogen Peroxide (For best results, change out the any unused Hydrogen Peroxide on an annual basis. This is the keep it fresh and active in case you have to use it.)
1 pound box of Baking Soda (transferred to a waterproof container
Dawn Dish Soap
Latex, plastic or rubber gloves (several pair)
A plastic or metal two-quart or larger container to mixing the ingredients (we used a gallon ice cream pail)
Measure one or more cups of baking soda into large container. Add 1/2 cup or more hydrogen peroxide to form a paste. Expect mixture to foam somewhat. Squeeze one or more ounces of liquid soap and while wearing protective gloves, hand mix the ingredients until smooth and slightly runny.
Hand rub mixture into dog’s coat with a massaging motion concentrating on the region where most of the skunk oil is located. Leave mixture on dog for 10 minutes or more. Then rinse with ample fresh water. Avoid getting the mixture in the dog’s eyes. Flush well with fresh water if it does get in his eyes.
Rinse the dog with plenty of fresh water.
NOTE: Do Not mix the solution before it is needed. It is unsafe to store this mixture for any length of time, so mix only when needed, apply immediately and discard afterwards.
We haven’t had to use our kit yet and hope we never have to, but we take it with us on each hunting trip. Of course I probably should do that on our hiking treks too.
A woman's view of hunting...with men 
We always used tomato juice, just bath in it, it works well.
Yeah but Orso would be lapping it up as fast as we would pouring it on him. He’s not too bright.
A new look Susan? I did a double take and wondered whether I was in another’s blog. Okay, will get some getting used to 🙂
I thought I needed a fresh new look. I hope it doesn’t scare off anyone. What did you think – new or old one?
I have heard that formula before and heard it works. I really need to have all those ingredients on hand.
Good luck, we have ours ready and hope we never have to use it.